Upgrade Your FLIR E6-XT!
Get the best resolution and new menu features in an hour.
Improve your FLIR E6-XT camera
After the upgrade your FLIR thermal imaging camera will get 320*240 resolution and all FLIR E8-XT firmware menu features.
Also your camera will be defined as a FLIR E8-XT model:
– in FLIR Tools (FLIR E8-XT mark in reports);
– on the camera's information screen and upon the boot up.
Upgrade is doing remotely, so you don't need to send your camera to us.
E8 Upgrade Service
$190 Supports FLIR E4 / E5 / E6 and E4-xt / E5-xt / E6-xt Best seller- New IR-resolution: 320 * 240 pixels
- New image modes: Picture in Picture (PIP), Thermal Blending
- Digital zoom: x2, x4, x8
- New measurement modes: Auto Hot Spot, Auto Cold Spot, Auto Hot + Cold + Center, Delta Hot Spot, Delta Hot Spot: Manual
- Manual Temperature Scale
Original E6 vs Upgraded E6/E8
Watch the difference between the original FLIR E6 firmware and upgraded E6 to E8 firmware with new menu features and 320x240 IR resolution.
Examples of Thermograms
Examples of FLIR E6 camera's thermograms after hack to FLIR E8 modification:
Electrical Board
Intersection Seam and Insulated Apartment
Cold Facility
100% Positive Feedbacks
Trusted by hundreds of customers in over 10 countries on eBay!
Comparison of Thermograms
Thermograms are made from one point with different FLIR cameras:
Original FLIR E4
FLIR E4 / E5 / E6 Upgraded to E8
FLIR E30 / E40 / E50 Upgraded to E60
Frequently Asked Questions
The most frequently asked questions about the updated FLIR thermal imaging cameras and the hack in general.
Are there any differences in hardware "from the box"?
There are no functional differences between Flir E4/E5/E6/E8 and E30/E40/E50/E60. All restrictions are imposed by software and can be unlocked.
Will hack void the warranty?
The manufacturer doesn't welcome interference in the internal software of the camera, however, if you need to send camera to service, it is possible to return the original software back.
Is there any risk that the upgrade
will be lost?
There is no risk that the thermal imager will be flashed back by itself. It is physically impossible. The upgrade can be lost only if you update camera to a newer firmware via FLIR Tools.
